Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

American Bosch 5AC
#25

OK so plug in the 80 tube and with the set on measure the DC +voltage from pin 1 or 4 to the chassis. Should see a couple of hundred volts. Next measure the DC voltage on pins 2 and 4 of the 47 tube separately to the chassis. Again should see a few hundred volts at both.
If you like I can send you a pm with my fone# Might be easier and quicker that all this typing!
Terry


Messages In This Thread
American Bosch 5AC - by dseverson - 06-16-2015, 03:29 PM
RE: American Bosch 5AC - by dseverson - 06-16-2015, 03:31 PM
RE: American Bosch 5AC - by jerryhawthorne - 06-16-2015, 04:05 PM
RE: American Bosch 5AC - by dseverson - 06-16-2015, 04:09 PM
RE: American Bosch 5AC - by Radioroslyn - 06-16-2015, 06:37 PM
RE: American Bosch 5AC - by jerryhawthorne - 06-16-2015, 08:20 PM
RE: American Bosch 5AC - by Radioroslyn - 06-16-2015, 09:24 PM
RE: American Bosch 5AC - by dseverson - 06-16-2015, 10:40 PM
RE: American Bosch 5AC - by jerryhawthorne - 06-16-2015, 10:59 PM
RE: American Bosch 5AC - by dseverson - 06-16-2015, 11:56 PM
RE: American Bosch 5AC - by dseverson - 06-17-2015, 12:13 AM
RE: American Bosch 5AC - by Arran - 06-17-2015, 02:55 AM
RE: American Bosch 5AC - by dseverson - 06-18-2015, 10:02 PM
RE: American Bosch 5AC - by dseverson - 07-04-2015, 05:38 AM
RE: American Bosch 5AC - by Radioroslyn - 07-04-2015, 06:33 AM
RE: American Bosch 5AC - by dseverson - 07-04-2015, 03:24 PM
RE: American Bosch 5AC - by Radioroslyn - 07-04-2015, 06:10 PM
RE: American Bosch 5AC - by dseverson - 07-04-2015, 11:17 PM
RE: American Bosch 5AC - by Radioroslyn - 07-05-2015, 09:37 PM
RE: American Bosch 5AC - by dseverson - 07-05-2015, 11:07 PM
RE: American Bosch 5AC - by Radioroslyn - 07-05-2015, 11:26 PM
RE: American Bosch 5AC - by dseverson - 07-06-2015, 01:13 PM
RE: American Bosch 5AC - by jerryhawthorne - 07-06-2015, 01:51 PM
RE: American Bosch 5AC - by dseverson - 08-07-2015, 05:27 AM
RE: American Bosch 5AC - by Radioroslyn - 08-09-2015, 09:21 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

[-]
Who's Online
There are currently 6282 online users. [Complete List]
» 1 Member(s) | 6281 Guest(s)
Avatar

>