Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

paint or no paint chassis
#3

I generally don't care for the bright look as I'm concerned about chassis rust down the road. I have panited a few over if they really rusty to preserve them.
https://www.flickr.com/photos/42774321@N...ateposted/

https://www.flickr.com/photos/42774321@N...ateposted/


Messages In This Thread
paint or no paint chassis - by KCMike - 08-08-2015, 08:33 PM
RE: paint or no paint chassis - by Kestas - 08-10-2015, 07:11 AM
RE: paint or no paint chassis - by Radioroslyn - 08-10-2015, 07:44 AM
RE: paint or no paint chassis - by OZ4 - 08-10-2015, 10:20 AM
RE: paint or no paint chassis - by KCMike - 08-10-2015, 01:38 PM
RE: paint or no paint chassis - by PhilcoJohn - 08-12-2015, 07:45 AM
RE: paint or no paint chassis - by Chuck Schwark - 08-12-2015, 09:22 AM
RE: paint or no paint chassis - by Eliot Ness - 08-12-2015, 02:17 PM
RE: paint or no paint chassis - by KCMike - 08-12-2015, 05:08 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4892 online users. [Complete List]
» 1 Member(s) | 4891 Guest(s)
Avatar

>