Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Would You touch this wi th a ten' pole?? I need my head examined!!!
#11

Hi Skip,
Just lucky (NOT)I guess! Or as Frankie Remley would say" I know a guy..."
This stuff came from Maryland, a friend of mine and myself where going to make a road trip of it but he had to bail at the last minute. So I made the trip down came back to friends house up in Yardely downloaded a few things and then home. Oh did I mention I had doc appt in Flemington NJ at 9:30am? I think I got back around 8pm.

One other thing that follow me home was a "E" coil pack for my HRO. They are pretty hard to come across and tune from 900kc to 2.0mc (upper part of the BC band though 160m). So now I have a full set covering 500kc to 30mc. That was from up here (a swap for a "D" coil).

If I get the RAS running it covers 190kc-30mc and it came with all of it coils, such as they are.

Sean, I saw that project eeck! At least mine doesn't smell. I don't think. Probably all the rain water wash it away. I'm alittle surprised that he mounted the p/s under the rx. Doesn't seem like a good idea. As for the rack it did have the two uprights but no top or base.

Terry


Messages In This Thread
RE: Would You touch this wi th a ten' pole?? I need my head examined!!! - by Radioroslyn - 08-11-2015, 06:23 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>