Firestone 4A22

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Firestone 4A22

Eric
Senior Member

Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA

08-13-2015, 07:51 PM

(08-13-2015, 06:30 PM)Radioroslyn Wrote: One other thing I forgot to mention is that that transformer is a bit of an overkill as it is for a push pull output and is good for 8w. I would not use it as your set doesn't require one that big. You'd be lucky to 2w on a good day. If you have any junkers around with SE output stage that are not battery/portables I would snatch it up and use rather that the hammond.

Terry

I hooked it up, I wanted to see if it would work or did I have other issues. it seems to play fine. Now I'm going to dig into the old one to see if I can fix it. and I do have some junkers in my shed so I'll look it see if I have one that is smaller. lots of veneer work to do so this will be awhile.
Thanks for the help.
Eric

Find

« Next Oldest | Next Newest »

Messages In This Thread

Firestone 4A22 - by Eric - 08-12-2015, 06:32 PM

RE: Firestone 4A22 - by Radioroslyn - 08-12-2015, 08:39 PM

RE: Firestone 4A22 - by Eric - 08-13-2015, 09:50 AM

RE: Firestone 4A22 - by Radioroslyn - 08-13-2015, 06:30 PM

RE: Firestone 4A22 - by Eric - 08-13-2015, 07:51 PM

RE: Firestone 4A22 - by Radioroslyn - 08-13-2015, 08:03 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 5350 online users. [Complete List]
» 2 Member(s) | 5348 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me