08-17-2015, 03:55 PM
Well, my best guess is that the 135 ohm 10W candohm needs replacing. It measures at 139 ohm but I have been reading lots of past posts about candohms measuring fine but still not functioning correctly. It is also the only component left that I have not replaced in this circuit. Am I correct in assuming that if it calls for a 135 ohm 10 W rated resistor that I can safely replace it with a 120 ohm and 15 ohm 10W power resistor in series?
Also, I still need to replace the .01 caps in the bakelite block between the power cord and transformer. This should be a Y-type cap?
Also, I still need to replace the .01 caps in the bakelite block between the power cord and transformer. This should be a Y-type cap?