RAS-1

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

RAS-1

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

08-24-2015, 10:00 PM

NUTZZZZ!!!
After further troubleshooting I confirmed the transformer is shorted. HV is fine but the heater winding is the culprit. Under load heater voltage is unstable from 4.5-6.0vac Off to the shed to see what I can replace it with.

Terry N3GTE

(This post was last modified: 10-27-2015, 08:00 AM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

RAS-1 - by Radioroslyn - 08-13-2015, 06:59 PM

RE: RAS-1 - by morzh - 08-14-2015, 10:05 AM

RE: RAS-1 - by Radioroslyn - 08-18-2015, 10:42 PM

RE: RAS-1 - by Radioroslyn - 08-24-2015, 07:19 PM

RE: RAS-1 - by Radioroslyn - 08-24-2015, 10:00 PM

RE: RAS-1 - by sam - 08-24-2015, 10:31 PM

RE: RAS-1 - by Radioroslyn - 08-25-2015, 07:12 AM

RE: RAS-1 - by Radioroslyn - 10-27-2015, 07:57 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W 1.5k ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM

Who's Online

There are currently 4369 online users. [Complete List]
» 1 Member(s) | 4368 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me