Help with a Philco 89B

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Help with a Philco 89B

kiwi_steve
A Kiwi, called Steve

Posts: 134
Threads: 11
Joined: Jul 2015
City: Christchurch, New Zealand

#24

08-30-2015, 08:54 PM

(07-29-2015, 08:06 AM)kiwi_steve Wrote:
(07-28-2015, 09:49 AM)morzh Wrote: Steve,

Before you proceed, do check tubes, check transformer with rectifier tube removed, check tubes, especially rectifiers, electrolytics polarity, and short after rectifier and across all filaments.

<snip>And checking for a short on the filaments is a good idea... I'll do that too since I'm reusing the original wire and it runs all along the chassis edge.</snip>

I was just reading back over this thread... And I just realised that I committed the sins of advice ignored, and promises broken Icon_lol

There are no personal problems that can't be overcome with the liberal application of high explosives

Find

« Next Oldest | Next Newest »

Messages In This Thread

Help with a Philco 89B - by kiwi_steve - 07-26-2015, 03:07 PM

RE: Help with a Philco 89B - by kiwi_steve - 07-26-2015, 03:34 PM

RE: Help with a Philco 89B - by Steve Davis - 07-26-2015, 05:11 PM

RE: Help with a Philco 89B - by morzh - 07-26-2015, 09:54 PM

RE: Help with a Philco 89B - by klondike98 - 07-26-2015, 10:02 PM

RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 07:44 AM

RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 07:59 AM

RE: Help with a Philco 89B - by morzh - 07-27-2015, 10:44 AM

RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 02:33 PM

RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 02:40 PM

RE: Help with a Philco 89B - by morzh - 07-27-2015, 03:14 PM

RE: Help with a Philco 89B - by kiwi_steve - 07-27-2015, 05:42 PM

RE: Help with a Philco 89B - by kiwi_steve - 07-28-2015, 02:51 AM

RE: Help with a Philco 89B - by sam - 07-28-2015, 03:00 AM

RE: Help with a Philco 89B - by kiwi_steve - 07-28-2015, 05:18 AM

RE: Help with a Philco 89B - by morzh - 07-28-2015, 09:49 AM

RE: Help with a Philco 89B - by kiwi_steve - 07-29-2015, 08:06 AM

RE: Help with a Philco 89B - by GarySP - 07-29-2015, 08:35 AM

RE: Help with a Philco 89B - by kiwi_steve - 07-29-2015, 05:10 PM

RE: Help with a Philco 89B - by kiwi_steve - 08-01-2015, 07:48 PM

RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 12:16 AM

RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 01:11 AM

RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 02:27 AM

RE: Help with a Philco 89B - by kiwi_steve - 08-30-2015, 08:54 PM

RE: Help with a Philco 89B - by kiwi_steve - 09-02-2015, 06:39 PM

RE: Help with a Philco 89B - by Arran - 09-03-2015, 01:03 AM

RE: Help with a Philco 89B - by kiwi_steve - 09-03-2015, 04:28 PM

RE: Help with a Philco 89B - by kiwi_steve - 09-22-2015, 05:18 PM

RE: Help with a Philco 89B - by kiwi_steve - 10-20-2015, 12:19 AM

View a Printable Version

Users browsing this thread: 10 Guest(s)

Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

Who's Online

There are currently 2997 online users. [Complete List]
» 1 Member(s) | 2996 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me