Philco 46-1209 Code 121

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 46-1209 Code 121

OZ4
Senior Member

Posts: 285
Threads: 27
Joined: Nov 2012
City: Tehachapi. California

#30

09-04-2015, 11:06 AM

Chase
I don't see unusual about those voltages they are not likely to be right on. As for the reception is the antenna correct? Are there any local stations to hear? (Where I live there are no local stations so all the radios I work on sound weak. I have to wait for night time.) If the antenna is correct I would look into the coils L1 and L2. Check their resistances. Sometimes they can open up.
You should be able to measure L2 in circuit and L1 you can measure if you disconnect the antenna.

If the coils check good then I would try an alignment.

!!!!!!!!!!!!!!!!!!!RESISTANCE IS FUTILE!!!!!!!!!!!!!!!!!!!!!!
/\/\/\/\/\/\/\/\/\

     [Image: http://philcoradio.com/phorum/images/smi...on_eek.gif] Chris

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 46-1209 Code 121 - by heats00 - 07-07-2015, 11:27 PM

RE: Philco 46-1209 Code 121 - by heats00 - 07-08-2015, 12:15 AM

RE: Philco 46-1209 Code 121 - by klondike98 - 07-08-2015, 12:20 AM

RE: Philco 46-1209 Code 121 - by codefox1 - 07-08-2015, 08:56 AM

RE: Philco 46-1209 Code 121 - by Radioroslyn - 07-09-2015, 06:03 PM

RE: Philco 46-1209 Code 121 - by heats00 - 07-16-2015, 10:27 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-06-2015, 02:19 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-07-2015, 12:05 AM

RE: Philco 46-1209 Code 121 - by heats00 - 08-08-2015, 02:30 AM

RE: Philco 46-1209 Code 121 - by heats00 - 08-09-2015, 01:46 AM

RE: Philco 46-1209 Code 121 - by heats00 - 08-12-2015, 09:04 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-17-2015, 03:55 PM

RE: Philco 46-1209 Code 121 - by klondike98 - 08-17-2015, 07:33 PM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-17-2015, 09:14 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-18-2015, 09:27 AM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-18-2015, 12:18 PM

RE: Philco 46-1209 Code 121 - by klondike98 - 08-18-2015, 01:02 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-19-2015, 01:00 AM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-19-2015, 11:13 AM

RE: Philco 46-1209 Code 121 - by heats00 - 08-19-2015, 03:23 PM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-19-2015, 07:22 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-20-2015, 10:56 PM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-21-2015, 11:33 AM

RE: Philco 46-1209 Code 121 - by heats00 - 08-21-2015, 03:49 PM

RE: Philco 46-1209 Code 121 - by heats00 - 08-30-2015, 11:21 PM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-31-2015, 11:05 AM

RE: Philco 46-1209 Code 121 - by heats00 - 08-31-2015, 12:28 PM

RE: Philco 46-1209 Code 121 - by OZ4 - 08-31-2015, 04:45 PM

RE: Philco 46-1209 Code 121 - by heats00 - 09-03-2015, 11:55 PM

RE: Philco 46-1209 Code 121 - by OZ4 - 09-04-2015, 11:06 AM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5217 online users. [Complete List]
» 1 Member(s) | 5216 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me