Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 41-285 cabinet scratches
#3

Thanks, Kurt. It worked pretty well. The small, shallow ones are gone, but a few of the deep ones remain. I might try to fill with wax touch up? Darn kids.

Went at it again, and got a pretty good result. I was able to blend in some tone and you kind of have to look for the scratches to see them, now.

While I'm looking at this cabinet, I know I'll need to put some toner on the darker parts (like the bottom trim and feet). I'm guessing that is going to be a Van Dyke Brown toner?

Charlie in San Antonio


Messages In This Thread
Philco 41-285 cabinet scratches - by ccomer1955 - 09-04-2015, 01:14 PM
RE: Philco 41-285 cabinet scratches - by ccomer1955 - 09-04-2015, 04:00 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 4641 online users. [Complete List]
» 1 Member(s) | 4640 Guest(s)
Avatar

>