Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Need help trying ID old Philco console.
#9

(09-20-2015, 06:40 PM)codefox1 Wrote:  Well, you can still pull it apart, and try to identify the chassis, may have some stampings or labels, and actually you could probably get it going again; might take a while; patience; small money.  Chassis might bring a (very few) dollars on classifieds here, if local, say $20.  No interest myself.  Got plenty of 'em.  Fun to work onThough.

I looked, but any markings that would positively ID the chassis are long gone.  There's a clean looking spot that probably used to have a label on it.  In the first set of pictures I posted, the bottom one shows some numbers that are inside the chassis.  There's also a number stamped into it (on the outside), which I suspect is a serial number.

   


Messages In This Thread
RE: Need help trying ID old Philco console. - by old_blue - 09-20-2015, 09:05 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently 1133 online users. [Complete List]
» 1 Member(s) | 1132 Guest(s)
Avatar

>