1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
My Latest Restoration - 46-1201
Guest
Unregistered
 
#1

03-05-2009, 08:47 PM
There has been a post or two concerning this model. The pictures show how I got around a a bad switch that I was unable to repair. I re-capped it, cleaned and lubed it. Replaced a couple resistors and fitted the idler wheel with an O-ring rather than have it rebuilt. It plays beautifully, the tone is good. I believe it is an early model. The code is 121 and is my first attempt on a set with an electodynamic speaker.

Microtouch

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.
« Next Oldest | Next Newest »


Messages In This Thread
My Latest Restoration - 46-1201 - by Guest - 03-05-2009, 08:47 PM
Re: My Latest Restoration - 46-1201 - by Guest - 03-05-2009, 10:17 PM
Re: My Latest Restoration - 46-1201 - by Guest - 03-06-2009, 07:27 AM
Re: My Latest Restoration - 46-1201 - by Guest - 03-06-2009, 04:56 PM
Re: My Latest Restoration - 46-1201 - by Guest - 03-09-2009, 04:44 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 3994 online users. [Complete List]
» 1 Member(s) | 3993 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration