Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 80 open coils
#16

Quick update and more interesting info. 

As mentioned I have been running this 80 in my shop down in the basement, with a 20 ft antenna and ground to a copper pipe.  I have been getting in AM 1370, 1230 anything high end of the dial coming in STRONG and great but 800 and 760 (stations usually equal to 1370) where fairly weak,  like 60%.

So curious about my correct IF I took the radio to check the LO with the only digital radio I have in my car out in the garage.  So I set the 80 next to the car antenna, hook up the 80 antenna (but with NO ground) and turn it on AM 800 so I can get a nice 450 or 460 above that easily.  Well BLOW ME OVER....that AM 800 was SOOOO strong and clear as was 760 it knocked my socks off!!  I go to try 1370 and 1230 and ffffftttttt NOTHING....or almost nothing.   I'll be d**ned!  LOL....

Long short my LO seems to be 460 and I take the radio back down to the basement and the previous set up and voila it is back to strong on 1370 and weak ish on 800 again.

So any ideas?  Is this just position and placement of the antenna?  Antenna length?   Could it be something with the antenna coil I re-wound? or is it just the nature of the beast being a 4 tube regen.

Looks like the fiddling around continues!

T


Messages In This Thread
Philco 80 open coils - by bastardbus - 09-25-2015, 01:07 AM
RE: Philco 80 open coils - by Radioroslyn - 09-25-2015, 07:54 AM
RE: Philco 80 open coils - by klondike98 - 09-25-2015, 11:52 AM
RE: Philco 80 open coils - by bastardbus - 09-25-2015, 01:11 PM
RE: Philco 80 open coils - by bastardbus - 09-25-2015, 01:14 PM
RE: Philco 80 open coils - by Radioroslyn - 09-25-2015, 05:48 PM
RE: Philco 80 open coils - by bastardbus - 09-25-2015, 10:23 PM
RE: Philco 80 open coils - by bastardbus - 09-26-2015, 01:21 AM
RE: Philco 80 open coils - by Radioroslyn - 09-27-2015, 11:07 AM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 11:24 AM
RE: Philco 80 open coils - by sam - 09-27-2015, 01:13 PM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 01:22 PM
RE: Philco 80 open coils - by Radioroslyn - 09-27-2015, 01:27 PM
RE: Philco 80 open coils - by sam - 09-27-2015, 01:30 PM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 04:00 PM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 06:24 PM
RE: Philco 80 open coils - by Radioroslyn - 09-28-2015, 07:38 AM
RE: Philco 80 open coils - by bastardbus - 09-28-2015, 04:50 PM
RE: Philco 80 open coils - by Radioroslyn - 10-01-2015, 04:55 PM
RE: Philco 80 open coils - by Radioroslyn - 10-02-2015, 05:50 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>