Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 80 open coils
#17

Not sure  Sound like it could be an ant problem being too short. back in the day radio antennas where run 5 or 10' above the roof line of the house and perhaps 50' to 100' long. Generally speaking the longer and higher the better. A half wave antenna for the BCB be about 750' long. Being in the basement with 20' of antenna  and maybe steel studs doesn't bowed well for your antenna.

One way to troubleshoot this problem would be to inject a signal at various point across the dial and use an analog ac volt meter across the voice coil of the spkr to see if the gain drops across the band.

Perhaps a weak 36 too could cause this issue.

Something else to try is:
http://www.philcorepairbench.com/tips/svctip43.htm

Terry


Messages In This Thread
Philco 80 open coils - by bastardbus - 09-25-2015, 01:07 AM
RE: Philco 80 open coils - by Radioroslyn - 09-25-2015, 07:54 AM
RE: Philco 80 open coils - by klondike98 - 09-25-2015, 11:52 AM
RE: Philco 80 open coils - by bastardbus - 09-25-2015, 01:11 PM
RE: Philco 80 open coils - by bastardbus - 09-25-2015, 01:14 PM
RE: Philco 80 open coils - by Radioroslyn - 09-25-2015, 05:48 PM
RE: Philco 80 open coils - by bastardbus - 09-25-2015, 10:23 PM
RE: Philco 80 open coils - by bastardbus - 09-26-2015, 01:21 AM
RE: Philco 80 open coils - by Radioroslyn - 09-27-2015, 11:07 AM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 11:24 AM
RE: Philco 80 open coils - by sam - 09-27-2015, 01:13 PM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 01:22 PM
RE: Philco 80 open coils - by Radioroslyn - 09-27-2015, 01:27 PM
RE: Philco 80 open coils - by sam - 09-27-2015, 01:30 PM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 04:00 PM
RE: Philco 80 open coils - by bastardbus - 09-27-2015, 06:24 PM
RE: Philco 80 open coils - by Radioroslyn - 09-28-2015, 07:38 AM
RE: Philco 80 open coils - by bastardbus - 09-28-2015, 04:50 PM
RE: Philco 80 open coils - by Radioroslyn - 10-01-2015, 04:55 PM
RE: Philco 80 open coils - by Radioroslyn - 10-02-2015, 05:50 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 1295 online users. [Complete List]
» 3 Member(s) | 1292 Guest(s)
AvatarAvatarAvatar

>