Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1935? Airline 62-136 help needed
#7

My late friend was going to make a battery eliminator for my Philco 30 after replacing any bad caps. Unfortunately, he decided to put the project off until fall and wanted to do a 'battery set day or weekend!' So, my 30 sat at his place for two months and he then ended up passing away. Icon_sad I'm missing chassis screws, but hopefully nothing else. I hope you can hear that Airline play again someday. Icon_smile

No matter where you go, there you are.


Messages In This Thread
1935? Airline 62-136 help needed - by SteveG - 10-05-2015, 11:45 AM
RE: 1935? Airline 62-136 help needed - by SteveG - 10-05-2015, 05:45 PM
RE: 1935? Airline 62-136 help needed - by Jayce - 10-05-2015, 11:45 PM
RE: 1935? Airline 62-136 help needed - by SteveG - 10-06-2015, 12:00 AM
RE: 1935? Airline 62-136 help needed - by Arran - 10-06-2015, 03:38 AM
RE: 1935? Airline 62-136 help needed - by JimZ - 10-06-2015, 11:52 AM
RE: 1935? Airline 62-136 help needed - by Jayce - 10-06-2015, 12:05 PM
RE: 1935? Airline 62-136 help needed - by SteveG - 10-06-2015, 12:13 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently no members online.

>