Dial face clean-up

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Dial face clean-up

SteveG
Senior Member

Posts: 330
Threads: 40
Joined: May 2015
City: Sanger, CA State, Province, Country: California

10-24-2015, 07:32 PM

I need to clean the plastic dial face on my Atwater Kent 80 before I put the chassis back in the cabinet. What's the best way to do that, without rubbing off the letters and numbers?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Dial face clean-up - by SteveG - 10-24-2015, 07:32 PM

RE: Dial face clean-up - by Radioroslyn - 10-24-2015, 08:14 PM

RE: Dial face clean-up - by SteveG - 10-25-2015, 10:31 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me