1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Pilot X-131 finished
Paul Philco322
Super Moderator
******
Posts: 4,382
Threads: 412
Joined: Jun 2011
City: Boston State, Province, Country: Massachusetts
#12

10-29-2015, 09:31 PM
Pilot was an interesting company, made stuff in New York and Massachusetts. I got beat on a large table set at a swap not long ago, it was not as sharp but had a unique look and very large knobs.

Good luck with that very fine looking set.

Paul
Tubetalk1
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Pilot X-131 finished - by SteveJB - 10-25-2015, 09:01 PM
RE: Pilot X-131 finished - by klondike98 - 10-25-2015, 10:10 PM
RE: Pilot X-131 finished - by VntgRads - 10-26-2015, 12:48 PM
RE: Pilot X-131 finished - by SteveJB - 10-26-2015, 03:33 PM
RE: Pilot X-131 finished - by mikethedruid - 10-26-2015, 09:59 PM
RE: Pilot X-131 finished - by Eliot Ness - 10-26-2015, 11:34 PM
RE: Pilot X-131 finished - by Fred Taylor - 10-27-2015, 07:40 AM
RE: Pilot X-131 finished - by leftwing25 - 10-27-2015, 04:03 PM
RE: Pilot X-131 finished - by SteveJB - 10-28-2015, 07:34 PM
RE: Pilot X-131 finished - by TA Forbes - 10-29-2015, 07:50 AM
RE: Pilot X-131 finished - by Crist Rigotti - 10-29-2015, 09:03 AM
RE: Pilot X-131 finished - by Paul Philco322 - 10-29-2015, 09:31 PM
RE: Pilot X-131 finished - by SteveJB - 10-30-2015, 06:56 PM
RE: Pilot X-131 finished - by Arran - 11-01-2015, 03:01 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4970 online users. [Complete List]
» 1 Member(s) | 4969 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)