1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
TRANSFORMER TO RESTORE - DO YOU KNOW ANYONE?
Guest
Unregistered
 
#4

04-22-2009, 04:11 PM
Hey guys, thanks for the advice.

I actually have teh original hardware and it is in good shape - only teh winding job has to be completed, possibly using the same bobbin.

I don't have teh XFMR data, but I am sure there is a datasheet somewhere (I thought I saw someone listing XFMR data for PHILCO). If you know exact place where the data can be found - I'd appreciate teh poitner.

I will give the Heyboer a buzz.
« Next Oldest | Next Newest »


Messages In This Thread
TRANSFORMER TO RESTORE - DO YOU KNOW ANYONE? - by Guest - 04-20-2009, 07:31 PM
Re: TRANSFORMER TO RESTORE - DO YOU KNOW ANYONE? - by Guest - 04-22-2009, 04:11 PM
Re: TRANSFORMER TO RESTORE - DO YOU KNOW ANYONE? - by Guest - 04-27-2009, 08:13 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM

[-]
Who's Online
There are currently 3186 online users. [Complete List]
» 2 Member(s) | 3184 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration