Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Radio Model 14 Code 122
#2

Hi

What you need is a 6 pole, 2 position rotary switch. I believe you may be able to get such a switch from Mouser Electronics, but you will probably have to come up with a way to lengthen the shaft to use in your radio. I bought one from them a few years ago for a Model 29 chassis that I never did restore.

http://www.mouser.com/

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco Radio Model 14 Code 122 - by Guest - 03-16-2009, 02:00 PM
Re: Philco Radio Model 14 Code 122 - by Ron Ramirez - 03-22-2009, 02:15 PM
Re: Philco Radio Model 14 Code 122 - by Guest - 03-23-2009, 03:58 AM
Re: Philco Radio Model 14 Code 122 - by Guest - 03-23-2009, 01:28 PM
Re: Philco Radio Model 14 Code 122 - by planigan - 03-27-2009, 12:45 AM
Re: Philco Radio Model 14 Code 122 - by planigan - 03-28-2009, 12:22 AM
Re: Philco Radio Model 14 Code 122 - by Guest - 03-28-2009, 07:33 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 5155 online users. [Complete List]
» 3 Member(s) | 5152 Guest(s)
AvatarAvatarAvatar

>