ozarka v16

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

ozarka v16

murf
Senior Member

Posts: 668
Threads: 144
Joined: Jun 2011
City: Elko,MN.

#14

11-06-2015, 09:30 PM

Hi Bob,A local radio enthusiast and I looked this chassis over tonight and have a few observations to report.we noticed tht the antenna coil was bypassed due to it being open,as well as a missing choke which had apparently burned out.Don\'t know if it was tied into to the tone control that is unhooked.Looks like the 10 mfd e-caps listed on the crappy schematics were at sometime replaced with 8mfd caps .these are marked on the cans.I need to find out from MR. OZARKA what I can do to replace the missing choke and wire it in to conform to the original schematic, as well as the wiring of the tone control.What a mess.I hope I am not offending a previous owner who might have made some of these mods years ago.I just need to get the required info to bring it back to life.Pics can be added. murf

(10-22-2015, 09:56 AM)joybird Wrote: GREAT find I know of a Person (Mr Ozarka) had 2 of these and that is it . Been collecting OZARKA 53 years, You better buy a lottery ticket today.

Re-cone the Speaker that is no biggy, I assume the Field and OT are OK

Find

« Next Oldest | Next Newest »

Messages In This Thread

ozarka v16 - by murf - 10-19-2015, 02:37 PM

RE: ozarka v16 - by radiohenry - 10-19-2015, 04:45 PM

RE: ozarka v16 - by Arran - 10-20-2015, 03:56 AM

RE: ozarka v16 - by JimZ - 10-20-2015, 08:14 AM

RE: ozarka v16 - by Arran - 10-20-2015, 10:22 PM

RE: ozarka v16 - by Jayce - 10-20-2015, 03:38 PM

RE: ozarka v16 - by Arran - 10-20-2015, 10:17 PM

RE: ozarka v16 - by TA Forbes - 10-22-2015, 09:24 AM

RE: ozarka v16 - by joybird - 10-22-2015, 09:56 AM

RE: ozarka v16 - by murf - 11-06-2015, 09:30 PM

RE: ozarka v16 - by jerryhawthorne - 10-22-2015, 03:26 PM

RE: ozarka v16 - by murf - 10-22-2015, 03:32 PM

RE: ozarka v16 - by joybird - 10-22-2015, 03:32 PM

RE: ozarka v16 - by murf - 11-06-2015, 10:00 PM

RE: ozarka v16 - by mikethedruid - 10-22-2015, 07:17 PM

RE: ozarka v16 - by Eliot Ness - 11-08-2015, 11:53 AM

RE: ozarka v16 - by murf - 11-11-2015, 07:47 PM

RE: ozarka v16 - by murf - 12-26-2015, 06:18 PM

RE: ozarka v16 - by joybird - 12-26-2015, 07:11 PM

RE: ozarka v16 - by rlongoria1 - 06-19-2019, 04:04 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 2755 online users. [Complete List]
» 1 Member(s) | 2754 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me