1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
my 37-61 project...
mikethedruid
Banned
Posts: 1,824
Threads: 114
Joined: Jul 2014
City: Sneedville, TN
#9

11-17-2015, 12:51 AM
Actually, I figure I REALLY only need 2 watt for the 202 ohm section, the 8 ohm section and the 35 ohm section could be 1/2 watt, which, of course, would be a cost saving. Again, using I squared R. Looking at the schematic for the 37-60, it used the same bias resistor. What have others used here ? As I said, advice appreciated before I plunge ahead.
Find
« Next Oldest | Next Newest »


Messages In This Thread
my 37-61 project... - by mikethedruid - 09-26-2015, 05:12 PM
RE: my 37-61 project... - by mikethedruid - 09-30-2015, 04:29 PM
RE: my 37-61 project... - by mikethedruid - 10-02-2015, 06:44 PM
RE: my 37-61 project... - by mikethedruid - 10-05-2015, 07:40 PM
RE: my 37-61 project... - by mikethedruid - 10-17-2015, 01:03 PM
RE: my 37-61 project... - by KCMike - 10-17-2015, 01:56 PM
RE: my 37-61 project... - by mikethedruid - 10-17-2015, 02:53 PM
RE: my 37-61 project... - by mikethedruid - 11-16-2015, 08:23 PM
RE: my 37-61 project... - by mikethedruid - 11-17-2015, 12:51 AM
RE: my 37-61 project... - by klondike98 - 11-17-2015, 01:46 AM
RE: my 37-61 project... - by mikethedruid - 11-17-2015, 03:06 AM
RE: my 37-61 project... - by mikethedruid - 12-09-2015, 10:08 PM
RE: my 37-61 project... - by kiwi_steve - 12-10-2015, 01:07 AM
RE: my 37-61 project... - by mikethedruid - 12-11-2015, 09:38 AM
RE: my 37-61 project... - by mikethedruid - 12-13-2015, 12:10 AM
RE: my 37-61 project... - by mikethedruid - 12-14-2015, 08:38 PM
RE: my 37-61 project... - by mikethedruid - 12-27-2015, 08:22 PM
RE: my 37-61 project... - by mikethedruid - 12-27-2015, 11:38 PM
RE: my 37-61 project... - by mikethedruid - 12-28-2015, 01:53 AM
RE: my 37-61 project... - by klondike98 - 12-28-2015, 10:20 AM
RE: my 37-61 project... - by mikethedruid - 01-01-2016, 01:53 AM
RE: my 37-61 project... - by mikethedruid - 01-27-2016, 03:58 PM
RE: my 37-61 project... - by KCMike - 01-27-2016, 05:35 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration