1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 40-135 Output Trans Replacement
Radioroslyn
Phorum Expert
*****
Posts: 7,221
Threads: 266
Joined: Dec 2009
City: Roslyn Pa
#5

03-18-2015, 03:14 PM
Hi Eric
You are measuring the DC resistance of the pri wind What is kind of important is the impedance not the resistance. Just hook it up as is. No resistor needed. Definitely replace #46( .006 connected to the plate of the 7B5 or 41) I already forgot which tube it uses. if it is shorted it will take out the op trans. Also the cap in the tone control will do the same.
Terry
(This post was last modified: 03-18-2015, 03:14 PM by Radioroslyn.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 40-135 Output Trans Replacement - by Eric - 03-09-2015, 03:43 PM
RE: Philco 40-135 Output Trans Replacement - by Radioroslyn - 03-18-2015, 03:14 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration