Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 80 Jr, just starting....
#22

(03-14-2012, 11:05 PM)morzh Wrote:  Well, today I've heard the strongest local station, "Good times oldies" from Lakewood NJ.

After I re-fitted all the Bakelite caps and re-stuffed the electrolytic caps (bought a bunch from Mouser - my company obliged piggibacking my order on theirs; otherwise the shipping is a killer with them), and replaced all the resistors, and washed the tuning cap, and...and.....when turned on, I realized one 36 type tube was not glowing, so I had to buy two tested tubes on Ebay.

So, with me acting as antenna, grabbing the antenna wire, I was able to tune in.
The music as not very loud. It is about where I would listen to it, but at the maximum volume setting.

I suspect I will have to tune the regenerative stage; after all the radio is really old and some parameters must have drifted by now.
Will have to look for the tuning procedure.

our voltages are about 10% high, and that does not bode well for tube life. I'd get a bucking transformer installed if you have room to tame it.


Messages In This Thread
Philco 80 Jr, just starting.... - by morzh - 01-28-2012, 08:35 PM
RE: Philco 80 Jr, just starting.... - by morzh - 02-28-2012, 11:21 PM
RE: Philco 80 Jr, just starting.... - by morzh - 03-14-2012, 11:05 PM
RE: Philco 80 Jr, just starting.... - by codefox1 - 03-15-2012, 12:25 AM
RE: Philco 80 Jr, just starting.... - by morzh - 03-15-2012, 09:44 AM
RE: Philco 80 Jr, just starting.... - by codefox1 - 03-15-2012, 11:20 AM
RE: Philco 80 Jr, just starting.... - by morzh - 03-17-2012, 12:14 AM
RE: Philco 80 Jr, just starting.... - by morzh - 03-21-2012, 02:35 PM
RE: Philco 80 Jr, just starting.... - by morzh - 03-21-2012, 10:03 PM
RE: Philco 80 Jr, just starting.... - by morzh - 03-21-2012, 09:56 PM
Re: Philco 80 Jr, just starting.... - by morzh - 01-29-2012, 02:24 PM
Re: Philco 80 Jr, just starting.... - by morzh - 02-05-2012, 05:23 PM
Re: Philco 80 Jr, just starting.... - by morzh - 02-06-2012, 05:31 PM
Re: Philco 80 Jr, just starting.... - by morzh - 02-11-2012, 07:25 PM
Re: Philco 80 Jr, just starting.... - by codefox1 - 02-11-2012, 08:50 PM
Re: Philco 80 Jr, just starting.... - by morzh - 02-12-2012, 10:14 PM
Re: Philco 80 Jr, just starting.... - by codefox1 - 02-13-2012, 03:22 PM
Re: Philco 80 Jr, just starting.... - by morzh - 02-13-2012, 05:37 PM
Re: Philco 80 Jr, just starting.... - by morzh - 02-15-2012, 11:50 AM



Users browsing this thread: 1 Guest(s)