Tube question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Tube question

Eric
Senior Member

Posts: 450
Threads: 84
Joined: Nov 2011
City: Cumming, GA

08-27-2012, 04:26 PM

Working on an Emerson CS-270 and I think I have a bad tube and have a question on a 6K8GT. The tube tester says it's good but when I check the filament voltage.
I only get 3 volts not the 6 volts I should and the others show 7 volts. Replace the tube ?

Eric

Find

« Next Oldest | Next Newest »

Messages In This Thread

Tube question - by Eric - 08-27-2012, 04:26 PM

RE: Tube question - by rghines1 - 08-27-2012, 06:37 PM

RE: Tube question - by Eric - 08-27-2012, 07:21 PM

RE: Tube question - by Arran - 08-28-2012, 12:02 AM

RE: Tube question - by Eric - 08-28-2012, 11:15 AM

RE: Tube question - by codefox1 - 08-28-2012, 01:12 PM

RE: Tube question - by Eric - 08-28-2012, 03:05 PM

RE: Tube question - by Arran - 08-29-2012, 06:46 PM

RE: Tube question - by Eric - 09-01-2012, 09:47 PM

RE: Tube question - by Steve Davis - 09-02-2012, 01:31 PM

RE: Tube question - by Eric - 09-03-2012, 09:00 AM

RE: Tube question - by 7estatdef - 09-03-2012, 03:47 PM

RE: Tube question - by Eric - 09-04-2012, 02:44 PM

RE: Tube question - by 7estatdef - 09-04-2012, 04:26 PM

RE: Tube question - by Eric - 09-06-2012, 12:20 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me