Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Mid-century portable 53-658
#16

(08-14-2015, 06:08 AM)Radioroslyn Wrote:  Looks like the mixer toob has a crack in it. Top looks awful white. Hope it's a 1R5 not that Z toob.
Good find.

Terry

 I don't think that Philco ever messed with 1L6s, not that I can see in the collection of diagrams I have. Not that it matters anyway since this is an AM broadcast set with that so called "special services band", which is basically just above the upper end of the B.C band. If it did use a 1L6 it could be easily switched to using a 1R5 with no ill effects. That would not be the case with many brand Z tube portables from that era, even if they were single band they still often used that silly tube, probably to get enough economy of scale to get a cheaper price from Sylvania who manufactured them.
Regards
Arran
#17

Nice to have the original graphics on the battery. Scan it and save the scan to the Phorum. It will allow others to reproduce that battery either with 9V/1.5V batteries installed in a case or to put in an A/C powersupply which is really not needed as your radio already has A/C operation. Good battery graphics are getting really hard to find. Nice radio.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM

[-]
Who's Online
There are currently 4572 online users. [Complete List]
» 2 Member(s) | 4570 Guest(s)
AvatarAvatar

>