Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

16b and model 20 pwr trans
#16

To be sure there are many 16B tombstones which have the 5 band chassis and which are factory correct this way. They also sold 16L consoles with 5 band chassis as well. You can tell if yours is correct by checking a couple of things. The earlier 16B tombstones have aless angled or peaked top than the later 4 banders. Also, the holes in the front panels are different. The 5 band chassis has a small hole at the tuning knob, as it has a single shaft which pulls in and out for fast and slow tuning. The 4 bander cabinets have a larger hole for the dual coententric knobs. The 5 band chassis in the 16B tombstone always has the 10 inch speaker hard wired to the chassis through the chassis, whereas the console sets used a plug in speaker arrangement.
#17

that settles it then,the chassis is not original,the speaker is not hardwired. no real biggee for me though. the seller is local and i'm familiar with him though not really friends. i emailed him about the "original " statement in the auction not quite being accurate. he refunded me $50 without me asking so i guess i'm o.k. with it,either way this radio is one helluva performer!
phil




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM
Philco 38-7 Speaker
7K should be fine. While not a perfect match (This transformer is meant for 6V6 tubes), Antique Electronic Supply (AES)...MrFixr55 — 08:03 AM

[-]
Who's Online
There are currently 2463 online users. [Complete List]
» 2 Member(s) | 2461 Guest(s)
AvatarAvatar

>