1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
35-1285 Record Changer Repair
R. Ramjet
Junior Member
**
Posts: 7
Threads: 1
Joined: May 2019
City: Wylie State, Province, Country: TX
#16

12-19-2020, 04:37 PM
I have finally gotten all of the rubber parts on the record changer either replaced or repaired.  I am starting to reassemble everything and find that the Trunnion Assembly (part number 35-2604) seems to be missing the rubber bushings , or whatever keeps the bottom shaft bearing from flopping around.  

I have the factory service manual, but the pictures of that part don't show enough detail to tell what's missing.  I also have another complete changer, but the Trunnion Assembly looks just the same - like a rubber bushing (or at least some kind of bushing) is missing.  The holes in the bracket are much larger than the pin that goes through the bearing.

Does someone have a working BOL changer?  If so, can you tell me how the Trunnion Assembly is put together?

I've attached a drawing of the assembly.


Attached Files Image(s)
   
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6190 online users. [Complete List]
» 4 Member(s) | 6186 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration