Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 077 signal generator
#1

I recently saw this nice example on ebay and decided it was finally time to get one.  It just arrived yesterday and I took a few photos.  It's smaller and lighter than I expected. The tubes appear to be originals and the controls operate smoothly. I have to restore it electrically soon and align some radios with it Icon_smile

Does anyone know what kind of AC cord plugged into the side or what the test leads look like ?

It's funny to see the same resistors and bakelite blocks used in their radios.
[Image: https://farm2.staticflickr.com/1661/2473...f540_z.jpg]

[Image: https://farm2.staticflickr.com/1458/2498...5941_z.jpg]

[Image: https://farm2.staticflickr.com/1444/2500...6cd3_z.jpg]

[Image: https://farm2.staticflickr.com/1701/2510...9677_z.jpg]


[Image: https://farm2.staticflickr.com/1486/2447...a029_z.jpg]
#2

Icon_thumbup Icon_thumbup Icon_thumbup




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 2740 online users. [Complete List]
» 1 Member(s) | 2739 Guest(s)
Avatar

>