Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

replacing missing loop antenna Philco 49-1405
#1

Hello everyone,
Ya I know it's me again !
Well I have another quick question dealing with this Philco model no. 49-1405 am/phono combo.
It's missing the internal loop antenna.
well in the schematic diagram all it shows is the resistance only 3.6 ohms .
There is a 5pf mica cap in parallel with it Far as a replacement I going to make new one up .
Any idea what lenght of wire to use there is a little of it left .
So I can figure the gauge of bare copper wire.
Sincerely Rich
P.S. heres the schematic again if needed
http://www.nostalgiaair.org/PagesByModel...013646.pdf
#2

Hi Rich

The 5 pF cap is in series with the external antenna lead.

Otherwise I'm afraid I can't help you much with this issue...

--
Ron Ramirez
Ferdinand IN
#3

Hello Ron,
Ya I noticed that after posting it .
Far as that antenna I'll see what I can come up with one guys on ARF gave me a idea .
HoW to figure what I need far as a antenna far as turns of wire and how to tune it using another radio set at the same 600 khz freg .
Sincerely Rich




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2808 online users. [Complete List]
» 1 Member(s) | 2807 Guest(s)
Avatar

>