Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 29-124 Chairside
#31

Read the bottom portion of the 2nd page of the above literature link that Nathan posted.  The "Inclined Sounding Board" in this unit allows the speaker to be against the chair without interfering with sound.  Interesting.

Craig R
#32

I thinks it's unusual that it has speaker cloth by the dial also. Maybe some sound bleeds out there too.
#33

(04-15-2016, 02:58 PM)SteveG Wrote:  I thinks it's unusual that it has speaker cloth by the dial also. Maybe some sound bleeds out there too.

That must be an integral part of the design.

Craig R
#34

I agree.  I think the top grill design must have been something about projecting the sound upward.  The 630CSX didn't have it, however, so maybe it didn't pan out with customers.

The 630CSX design says customers wanted the sound to project out into the room more, rather than upward.  But that upward-facing grill is absolutely the defining feature of the 28/29CSX.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 3155 online users. [Complete List]
» 1 Member(s) | 3154 Guest(s)
Avatar

>