1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Sears 6130: Reception problem
leftwing25
Member
***
Posts: 85
Threads: 13
Joined: Jul 2015
City: Rockville, MD
#1

06-16-2016, 03:06 PM
Hey all. Re-capped , re-resistored, aligned to the best of my ability(maybe that's the problem). Now it seems that it passes signals from the signal generator, but only picks up one strong station about a mile away at 1600kc. All tube voltages are normal. Did a check on the oscillator and it looks as if it cuts out at about 1400kc. Grid goes positive to about 5.5 volts at lower end of the dial. Thought it might be the cathode resistor
on the oscillator, but subbing for that didn't help. Any suggestions are gratefully welcome. Thanks, Ed
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,273
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

06-17-2016, 06:55 PM
Check ur PM box.

Terry
Find
« Next Oldest | Next Newest »




Users browsing this thread:
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)