Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

ID this Bracket on Philco 16B chassis
#1

Can't figure what it was used for.
Original to this chassis.

Bob T


Attached Files Image(s)
   
#2

The bracket does not belong there. Someone added it for who knows what.

Steve

M R Radios   C M Tubes
#3

+1 what Steve said.

--
Ron Ramirez
Ferdinand IN
#4

I think it was used tohold an antenna maybe.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#5

Like they said.
Definitely not factory original.  Dealer or owner add-on.
#6

Attached to the other side of this bracket is the Wave Trap Assembly (PHOTO)

Inductive Wave Trap with Compensating Assembly

Items 3 and 4 on Parts list

It is covered with a soft crystal looking material. Do not know what that is

Will clean later and see if coil still good.


Bob T

The Crystal Material looks like the goo when a Battery leaks.
Just had one yesterday AAA Battery leaked and looked the same.


Attached Files Image(s)
   
#7

I believe that Bracket was added.
Its use was to hang the Antenna Wire on

I saw another one , not same Bracket , but had about 20 feet of wire wrapped and hung on the bracket.

So I stand by my answer and that is all there is to it.

No don't try to change my mind, it is made up.



Any other ideas Icon_crazy 

Bob T




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5281 online users. [Complete List]
» 2 Member(s) | 5279 Guest(s)
AvatarAvatar

>