Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

grill cloth woes
#1

Hi guys,  I have a Philco 44 highboy that I restored a couple of years ago.  Getting ready to put in an order for some grill cloth.  What is on there now isn't bad at all but the cloth is heavy and the wrong pattern.  I would like to get as close as possible to the original.  Looking at Radio Daze inventory, would "GRC02" pattern be the closest?  http://www.radiodaze.com/grille-cloth/  I am having a hard time finding what the original pattern looked like.  There should be an attached pic of the radio.

Thanks


http://s350.photobucket.com/user/Don_Ray...sort=3&o=0
#2

No one ever made an accurate pattern of the cloth which your 44H had originally.

That said...Kenny Richmond's "Whiskey Rayon" or the GRC02 from Radio Daze would be good substitutes.

http://richmonddesignsinc.com/grille_cloth_product_page

http://www.radiodaze.com/grille-cloth-02-item-grc02/

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron, that is the one I was going for, just wasn't quite sure if that was the closest.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 2716 online users. [Complete List]
» 4 Member(s) | 2712 Guest(s)
AvatarAvatarAvatarAvatar

>