Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

GE F-96 wood repair
#1

I'm working on a F-96 and it has a chunk taken out of it.


[Image: http://i.imgur.com/4fmxl9r.jpg]
Anyone have a better sense of wood identification than me? I'm going to try a veneer patch, but I suppose I better know what wood I'm looking for.
#2

Has the side pulled away for the top?? The contour of the side doesn't look like it matches the top. Are you thinking of refinishing the whole cabinet or just repairing this issues?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

I am not an expert, but that looks like mahogany, AKA luan plywood.
#4

Im refinishing it completely. I've reglued the loose edge to the top. I've stripped and sanded. I have some veneer samples coming.

I'm not sure how to approach the missing substrate issue.
#5

(08-10-2016, 08:05 PM)kc5gym Wrote:  I am not an expert, but that looks like mahogany, AKA luan plywood.

No, It's not Luan plywood, it's one of the mahogany look a likes, sapele. or possibly quartersawn makore. G.E listed what sort of veneers they used in their advertising and I think that they liked to use one of those veneers, particularly of the ribbon striped variety, on their cabinets in the 1938 and 39 model years.
 
http://www.wood-database.com/lumber-iden...ds/makore/

http://www.wood-database.com/lumber-iden...ds/sapele/

Regards
Arran
#6

(08-12-2016, 03:38 AM)Arran Wrote:  
(08-10-2016, 08:05 PM)kc5gym Wrote:  I am not an expert, but that looks like mahogany, AKA luan plywood.

No, It's not Luan plywood, it's one of the mahogany look a likes, sapele. or possibly quartersawn makore. G.E listed what sort of veneers they used in their advertising and I think that they liked to use one of those veneers, particularly of the ribbon striped variety, on their cabinets in the 1938 and 39 model years.
 
http://www.wood-database.com/lumber-iden...ds/makore/

http://www.wood-database.com/lumber-iden...ds/sapele/

Regards
Arran

That Makore looks like a possibility.
#7

(08-12-2016, 07:40 AM)Tgace459 Wrote:  
(08-12-2016, 03:38 AM)Arran Wrote:  
(08-10-2016, 08:05 PM)kc5gym Wrote:  I am not an expert, but that looks like mahogany, AKA luan plywood.

No, It's not Luan plywood, it's one of the mahogany look a likes, sapele. or possibly quartersawn makore. G.E listed what sort of veneers they used in their advertising and I think that they liked to use one of those veneers, particularly of the ribbon striped variety, on their cabinets in the 1938 and 39 model years.
 
http://www.wood-database.com/lumber-iden...ds/makore/

http://www.wood-database.com/lumber-iden...ds/sapele/

Regards
Arran

That Makore looks like a possibility.

 Better strip some of the original finish off, just to make sure, G.E was like many manufacturers in that their cabinets had a tinted finish over everything to even out the variations in wood grain.
Regards
Arran




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 3849 online users. [Complete List]
» 3 Member(s) | 3846 Guest(s)
AvatarAvatarAvatar

>