Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

51-532 Knobs
#1

Hello, I'm new here this is my first post, need both knobs for this radio 51-532 any ideas.
Thanks
Jim

Jim
Spring Lake MI
#2

Welcome to the Phorum!
Icon_wave

You can try a couple of approaches for those knobs.  
1) Check with the folks that are in the knob business.  I've used most of the people on the lists found on this page in the Resources section.
You may need to send a picture of the knobs you are looking for.  Some photos can be found on the Gallery pages.

2) Post in the Wanted Ads section and you may find someone has a set or some spare knobs.
#3

(07-28-2016, 08:51 AM)klondike98 Wrote:  Welcome to the Phorum!
Icon_wave

You can try a couple of approaches for those knobs.  
1) Check with the folks that are in the knob business.  I've used most of the people on the lists found on this page in the Resources section.
You may need to send a picture of the knobs you are looking for.  Some photos can be found on the Gallery pages.

2) Post in the Wanted Ads section and you may find someone has a set or some spare knobs.
Thanks
#4

Found some.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5399 online users. [Complete List]
» 2 Member(s) | 5397 Guest(s)
AvatarAvatar

>