1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco 42-1010 Veneer - European Walnut?
AVSorrell
Member
***
Posts: 76
Threads: 18
Joined: Nov 2015
City: Palmyra State, Province, Country: Virginia
#1

10-01-2016, 10:13 AM
Hi Guys -

I have a Philco 42-1010 that has some lost veneer that I am going to replace. One the below photo it is the area on the front below the grille that looks obvious in its veneer loss. Anyhow I gently pulled some more of the loose stuff off to look at the back. Is this the European walnut veneer Philco liked to use?  I will attach some photos below. Thanks for the advice! -- Andy

https://flic.kr/p/MHPRau
Full Radio

https://flic.kr/p/MDrf2M
Close up of Area

https://flic.kr/p/LPqm6H
finished side on veneer

https://flic.kr/p/MAM5Hq
unfinished side
Andy Sorrell
Palmyra, Virginia
(This post was last modified: 10-01-2016, 10:18 AM by AVSorrell.)
Find
Arran
Phorum Expert
*****
Posts: 4,707
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#2

10-03-2016, 03:49 AM
 It's French Walnut, regular cut I think, sometimes Philco cabinets used quarter sawn French walnut but that is very straight grained. Have a look on fleabay if you need some, though you may have to buy 15 square feet of it or more.
Regards
Arran
Find
AVSorrell
Member
***
Posts: 76
Threads: 18
Joined: Nov 2015
City: Palmyra State, Province, Country: Virginia
#3

10-06-2016, 12:26 PM
Thanks Arran!
Andy Sorrell
Palmyra, Virginia
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration