Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 39-116
#1

Where can I find the tube layout and schematic for a Philco Model 39-116?
#2

Welcome to the Phorum!
Icon_wave

A free schematic can be found on nostalgiaair.org
http://www.nostalgiaair.org/Resources/266/M0013266.htm

The Service Bulletin #310 is available on the audiophool site:
http://www.audiophool.com/Philco.html

( the reader for the djVu file is here; https://www.cuminas.jp/en/downloads/download/?pid=1 )

A more readable set of schematics and info can be had for a few bucks from Chuck.

www.philcorepairbench.com/schematics.htm

For more resources that might be helpful, see:

http://philcoradio.com/phorum/showthread.php?tid=14950
#3

Thank you!  That's great information!  I've got a check going out to Chuck today!
Tim
#4

(09-28-2016, 07:13 PM)klondike98 Wrote:  I just watched a Philco factory tour video on Youtube. Here is a link:
https://www.youtube.com/watch?v=kanPsUDyKrU
Welcome to the Phorum!
Icon_wave

A free schematic can be found on nostalgiaair.org
http://www.nostalgiaair.org/Resources/266/M0013266.htm

The Service Bulletin #310 is available on the audiophool site:
http://www.audiophool.com/Philco.html

( the reader for the djVu file is here; https://www.cuminas.jp/en/downloads/download/?pid=1 )

A more readable set of schematics and info can be had for a few bucks from Chuck.

www.philcorepairbench.com/schematics.htm

For more resources that might be helpful, see:

http://philcoradio.com/phorum/showthread.php?tid=14950
#5

Hi ozo,
Welcome to the Phorum!
Icon_wave
I think you're trying to post something...give it another try.
#6

The remarks re: the youtube video of Philco's Factory Tour was my first post and had to go through moderation. I mentioned it because it is free but in the list of resources it was not. There are many videos on you tube but you have to look. Just plug in your model number and there may be videos of it including repair tutorials.

Here is an example of a youtube video of a huge Philco radio collection I liked.  
https://www.youtube.com/watch?v=7Eb35g1vqH4

Yea I am a new guy and glad to be here. I started out collecting vintage audio gear like receivers, amps, turntables, and tape decks but could not afford tube amps. Then I got my first tube radio and now have five. Three are Philcos; 48-482, 39-75, and a 46-421.
#7

Thanks for watching, Ozo. Glad you liked my videoIcon_smile

Greg V.
West Bend, WI
Member WARCI.org
#8

(10-18-2016, 05:43 PM)NostalgiaRadioTime Wrote:  Thanks for watching, Ozo. Glad you liked my videoIcon_smile

It is well done and I liked the earlier one too. I was watching the 2016 video for a while before I realized it was the same collection only on steroids. Icon_clap
#9

Ha! It's changed even since the 2016 video...I thinned it out a bit. Down to 75 now.

Greg V.
West Bend, WI
Member WARCI.org




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4287 online users. [Complete List]
» 1 Member(s) | 4286 Guest(s)
Avatar

>