Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Capacitor color code?
#1

Im new to working on electronics. I did do alittle work when I was in highschool but that was along time ago. Anyhow Im working on an old philco console record player. It has a pre amp that probaly needs new capacitors. I came across two of them that are color coded. They look very simular to a resistor. They are round and are black about a half inch in diameter, and 1 1/2 inches tall. The colors bands are yellow, purple, orange, black and blue. Wich end do you start from? Could it be a .047 uf ? Or .06 uf ? or am I way off? All the other capacitors are 400 volts. Is this one 400 volts also? does that mean the yellow is the last band? I can't seem to find any info. on this machine. Model H1816, sr 21246. Does anyone know ware I can look up some info? Thank you.
#2

That's 4, 7, three zeros, for .047 as you suspected. Blue is 600 volts. These are always leaky by now and will definitely need replacing.
#3

Ok thanks




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM

[-]
Who's Online
There are currently 2892 online users. [Complete List]
» 1 Member(s) | 2891 Guest(s)
Avatar

>