Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1934/35 Radio Question
#1

I have a 34 radio which has parts in in from 35.  I cannot tell the difference between the 34 ashtray radio and the 35/6 open car radios.  There is a definite difference between open car radios and closed car radios for 35/6.  I am looking for a 34 head to go with my radio.
#2

Welcome to the Phorum!
Icon_wave

I created a new thread for this, its kind of a combination question and wanted item so we'll leave it here for now so your thread doesn't dissappear in 30 days which is what would happen in the Wanted Ads section.

Hope you get some answers!
#3

I think that one of the control connections [volume and tuning] in the model N is female, both male in FT-6.  
you can also compare schematics.  one for the model N is in the may-june ford service bulletin, pg 192, the FT-6 on line at http://www.nostalgiaair.org/pagesbymodel...014014.pdf
 at the least, you can compare the FT-6 pictures on line to your radio. in particular, check the location of the output transformer, part no. 46. in the FT-6, it's bolted to a vertical plate right in the middle of the radio. in the model N, it's bolted to a horizontal plate beside the vibrator on the tube side of the radio.
 good luck.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently 1504 online users. [Complete List]
» 1 Member(s) | 1503 Guest(s)
Avatar

>