Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

schematic needed for 38-93b
#1

Further to my search for a circuit with a previous posting, I may have identified my radio after receiving my copy of Antique Radios by John Slusser. Would any one have a copy of the above model please ?

Regards
Rudy
#2

Rudy,
A note on this radio a radiomuseum.org says that you should use service info for 37-93:
http://www.radiomuseum.org/r/philco_38_93b_2.html
The schematic can be found here:
http://www.nostalgiaair.org/PagesByModel...013228.pdf

Carl
Northern Panhandle, WV
#3

Thanks for your reply Carl. Unfortunately the tube line up on Radio Museum did not line up with mine, also I couldn't get into Nostalgia Airs site for some reason. I shall keep trying.
Regards
Rudy
#4

Rudy,
What is the tube line up in yours?

Carl
Northern Panhandle, WV




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM

[-]
Who's Online
There are currently 5660 online users. [Complete List]
» 2 Member(s) | 5658 Guest(s)
AvatarAvatar

>