Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 48-482 Decals
#1

Hi, I am finishing off a restoration of a Philco 48-482 and have turned to the cabinet. It is currently sitting in a sanded down state and I thought Radiodaze possibly had decals for that model, but I cannot find any. I have the large Philco decal so I am fine there, but I do not have the other dial decals including Bass, Treble, Volume, and "Dial Tuning."

There are various models of the Philco line that have possibly decals I could use, but 1) I don't know if they would work with my model in terms of the curvature of the knob, etc. and 2) I'd rather not buy multiples of various models to get what I need.

Any suggestions on any other place that might have decals for this model or how to overcome this issue?

Thanks as always,
Jim
#2

I think this one has what you need:
Volume, Dial Tuning, Treble, Bass

http://www.radiodaze.com/philco-48-1270-...h-48-1270/

Its what i used if i recall.
#3

Thanks! Just wanted to be sure before I ordered.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>