Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phorum How-To #17: Mark Forums as Read
#1

Quite simple, really...

If you visit one of the forums within the Phorum, read the threads you want to read, and then want to mark the rest as "read" all at once - proceed as follows:

Let's assume you are in Philco Home Radios.

Look close to the top of the page, to the right of where it reads Philco Home Radios and under the big Post Thread button.

Look for the Mark this forum read link (see below).

[Image: https://philcoradio.com/images/phorum/Ph...17_001.jpg]

Click or tap it.

You will then see this message:

[Image: https://philcoradio.com/images/phorum/Ph...17_002.jpg]

The message will go away in a few seconds and you will be back on the main page of the forum you were in.



Now let's say you visit the Phorum, but don't want to read any of the threads in any of the forums. You want to mark all of them as "read".

Just scroll all the way down to the bottom of the Phorum home page and look for the Mark All Forums Read link as shown below (the view on phones is similar):

[Image: https://philcoradio.com/images/phorum/Ph...17_003.jpg]

Click or tap it, and then you will see this message:

[Image: https://philcoradio.com/images/phorum/Ph...17_004.jpg]

In just a few seconds, the Phorum home page will reappear.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM

[-]
Who's Online
There are currently no members online.

>