Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 50-922
#1

All, Just started on this.. The outside cleaned up nicely ..

[Image: https://farm5.staticflickr.com/4428/3741...9f67_b.jpg]

But looks like the pointer is not original.. Can someone confirm this...


[Image: https://farm5.staticflickr.com/4469/3689...7956_b.jpg]

Doesn't look to bad on inside..So should be a easy recap..

Skip...
#2

Skip;
  I believe that the pointer is original, but has been repaired by someone at some point, I'm pretty sure that the original was clear plastic just like it was in the hippo models that preceded it. One item that may turn out to be a headache are the mini IF cans these have, they can develop intermittent contact between either leg of the IF coils and the silver mica caps, it's actually more common then silver migration though that can happen too.
Regards
Arran
#3

   
Good Morning link to nostalgiaair http://www.nostalgiaair.org/pagesbymodel...013702.pdf   and info from beitmans




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
I think after all has been said, I will use the same bulb that is specified for the dial pilot light which is a #55. I ...georgetownjohn — 07:31 PM
12' Philco
There was also this Philco! klondike98 — 07:25 PM
HiFi (Chifi) tube amp build - but my own design.
I expected a challenge and this is just part of it. But, it's also supposed to be fun, entertaining, informative and enj...TV MAN — 07:12 PM
Shadow Meter Bulb
Butting in here with a question. Since the shadow meter is connected directly to the 1st and 2nd I.F.'s wouldn't the met...RossH — 06:43 PM
HiFi (Chifi) tube amp build - but my own design.
Mike, Tim; you are about to enter the twilight zone. Doo doo doo doo, doo doo doo doo This is something alright. I'm go...RodB — 06:26 PM
HiFi (Chifi) tube amp build - but my own design.
:lol: We need to start a singing radio group! I play the guitar, so maybe get a few vocals? Anyways, Mike, I did try mou...TV MAN — 05:56 PM
HiFi (Chifi) tube amp build - but my own design.
And so does a barber shop quartet. mmmmmmRodB — 03:54 PM
Shadow Meter Bulb
I did try an LED bulb in place of the original but wasn't impressed with the amount of light on the dial. Seems like it ...RodB — 03:51 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Would mounting he transformer vertically change the hum, if used without additional parts? Also, in these amps...morzh — 02:25 PM
Shadow Meter Bulb
Gary I doubt it would introduce any noise. We use similar lamps for the panel indication, 12V AC lamps: they are LEDs...morzh — 02:15 PM

[-]
Who's Online
There are currently no members online.

>