Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 118X cabinet colors
#1

I need to refinish this cabinet and want to find the correct colors or stain for the contrasting woods.

Can anyone steer me to the appropriate colors and a vendor for them?

Is there a vendor for the Pilco small decal on the front? Does anyone know if there were other decals/markings for the controls?

Thanks
#2

I apologize for missing this post until now.

It depends on which version of the 118X you have.

The early one:
http://www.philcoradio.com/gallery/1935a.htm#ak

Medium Walnut overall, with Perfect Brown on the horizontal accent stripe near the center of the cabinet and Extra Dark Walnut on the two sections of the fluting above the dial, as shown.

The later, and more common one:
http://www.philcoradio.com/gallery/1935b.htm#f

It uses Medium Walnut on the control panel, sides and top; Extra Dark Walnut on the trim, as shown.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5110 online users. [Complete List]
» 1 Member(s) | 5109 Guest(s)
Avatar

>