Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1934 Packard Car Radio Information
#1
Photo 

Hello,
Can anyone help me locate service literature for a Packard (Philco) P-9 Code 122 car radio?
Here is a photo of the decal inside the set.

Thanks,

Paul


Attached Files Image(s)
   
#2

OK, apparently a model listed as a Philco Model 9 in NA. is very similar to the P-9. Tube compliment is the same, and I will investigate if they are one-in-the-same radio. 

Can anyone confirm this?
#3

Welcome to the Phorum!
Icon_wave

Have not worked on any car radios so can't help you but others may have info.
#4

The power supply looks like it was off board connected to a female ended cable, which could have been connected to either sets of batteries, or a vibrator supply, the tube filaments may or may not have been in series. The earliest car radios were very much like a farm or portable radio installed in a car with a set of "A","B", and "C" batteries to power it, and almost all were aftermarket installations, Packard may have been one of the earlier marques to offer a radio as a factory option since they were higher end cars to start with. I could look in my Philco factory manual but I'm not sure if it has any car radio schematics in it, it was given to me by an uncle who tended to eschewcar radios and TV schematics so they may have been edited out of the binder.
Regards
Arran




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 2757 online users. [Complete List]
» 1 Member(s) | 2756 Guest(s)
Avatar

>