Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

turn the philco 53 707 into a lamp radio
#1

i just aquired a philco 53 707 clock radio at the top is a factory hole for a lamp.inside the radio is a sticker that states to use only a philco lamp attachment. so my question if i do put a lamp on this set will it effect the value much .i know you purest might throw up at the thought however it was made to have a lamp. thanks for the info
#2

I just looked this set up.

Models 53-706 and 53-707 are identical except for the cabinets, and the fact that the 706 came from the factory with the lamp while the 707 did not.

You might lower the value slightly by adding a lamp to the 707, but right not these are not really "hot" collectibles so I say it's your radio, use the factory hole for a lamp if you wish since the manufacturer apparently gave that option to the original owners. Icon_smile

--
Ron Ramirez
Ferdinand IN
#3

thanks ron ,do you know where I can find a picture of one colored so I can restore it to original state again thanks for your time




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently 3364 online users. [Complete List]
» 5 Member(s) | 3359 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>