Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-380 cabinet update
#1

[Image: http://i833.photobucket.com/albums/zz254...000192.jpg]
Just got the cabinet back from the furniture restoration shop. They stripped and refinished the cabinet without redoing the photo finish, one it cost too much and two I'm not much into faux finishes. They made it look like many of the cabinets of that period and we went over photo's of various radio cabinets and decided on a dark mahogany to complement the existing finish. Cost was $308.00. Overall good job. There was one problem where the veneer rounds over the top. When I got it home there appeared to be a small white line about 2" long. It turned out to be a crack in the veneer under the varnish. It's back getting that fixed. We might end up replacing the veneer anyhow depending on how sucessful the repair goes.
#2

Looks pretty good... Icon_smile

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4000 online users. [Complete List]
» 3 Member(s) | 3997 Guest(s)
AvatarAvatarAvatar

>