Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Broadcast Bands?
#1

Does anyone broadcast anything anymore on the short wave, long wave or police bands?
#2

Broadcast band is what is commonly called "AM radio" Yes, there are many stations on that band. It runs from 550 KC to 1600 KC, and is mostly talk radio these days, but there are a few music stations too. The shortwave bands are still used and there are many stations from around the world that broadcast programs of news from their nation and their nation's point of view, local culture and music. You can find stations in the range of 5 MC to about 8 MC with ham bands just above 7 MC, more international stations between 9 MC and 10 MC, and still more between 11 MC and 12 MC. You can find listings of the frequencies and times of these broadcasts on the net.here is a link to one site  http://www.primetimeshortwave.com/  . The police band that falls between these areas, 1600 KC to 5 MC is pretty much dead for general listening. You can find the u. S. National Bureau of Standards time signal at 5.00 MC and 10.00 MC it is a good standard to check your alignment.
#3

Thanks Mike, yes I was aware of the AM broadcast. I assumed it was the band labeled "Standard Broadcast". It was the other three I wasn't sure about.
I also have another radio with the four bands on the dial, but instead of the band labeled "Police" it is labeled "Amateur". Would this be the same or more for the ham radio operator type of thing?
#4

The police band on these old set haven't been used by the police since before wwII. Nowadays it's all vhf and uhf fm. LW band is pretty useless short of a small ham band and a couple of navigational signals that are transmitted in Morse code. Bands that have Amateur markings still are ham bands and since the 80's a few more have been added.
These days there are a lot of modern devices that generate a lot of interference in the lw/mw/sw bands. Phone and laptop chargers are some of the worst offenders. They use what known as switch mode power supplies. They make buzzy noises all over the spectrum.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Got it. Thank you.
#6

in the old Police band you will now find some Amateur frequencies, you can find a listing of them here, http://www.arrl.org/frequency-allocations . You will also find the amateur frequencies for bands in the longwave spectrum, and in the shortwave spectrum above the old "police band".
#7

Thanks Mike. I will search them out.
#8

Thanks for asking this question, I , too, wondered the same.




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

[-]
Who's Online
There are currently 3243 online users. [Complete List]
» 1 Member(s) | 3242 Guest(s)
Avatar

>