Philco 42-1013P Dimensions
Posts: 1,889
Threads: 214
Joined: May 2015
City: Seattle
State, Province, Country: WA
Anybody know the dimensions (especially height) of the 42-1013P?
http://philcoradio.com/gallery2/1942a/#Model_42-1013P
I'm going to look at one this weekend - and ideally buy it too! - but it's a drive and I'm worried it won't fit in the car.
I've asked the seller but they either don't own a measuring tape or...?? but haven't been able to provide a very precise answer.
Also - any general hints on transporting these BOL sets? Is the phonograph likely bolted down or should it be removed for transport?
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
I don't have the measurements but I have seen one before, many years ago, and I can tell you that radio is yuuuge!
I would take a truck. A full size truck. And not one of those more recent "big car" trucks with four doors and a shorty bed. Oh, and take a helper, too - they aren't lightweight!
The phono should be bolted down unless someone tinkered with it. Be sure and tie up the tone arm so it does not move around in transport.
--
Ron Ramirez
Ferdinand IN
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
I went to the basement and looked it up. Philco Furniture History gives these dimensions:
36" high, 40" wide, 15" deep.
Good luck.
--
Ron Ramirez
Ferdinand IN
Posts: 1,889
Threads: 214
Joined: May 2015
City: Seattle
State, Province, Country: WA
Thank you sir!
It sounds like it would just fit in the back of the SUV. Not ideal though. I may remove the chassis and phonograph from the cabinet to make it a bit easier to move.
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
Good idea.
The cabinet alone will still be heavy. Do your back a favor and take a helper along.
--
Ron Ramirez
Ferdinand IN
Posts: 1,889
Threads: 214
Joined: May 2015
City: Seattle
State, Province, Country: WA
Mission accomplished! Yesterday I drove to Seaside, OR after the NWVRS radio picnic and swap meet to pick up the 42-1013P.
I was planning to take out the phonograph and chassis to lighten things up... but man are there a lot of wires going on and not all appear to be socketed:
[Image: https://farm2.staticflickr.com/1789/4250...a76f_c.jpg]
Fortunately the seller was kind enough to help me load it into the car without taking it apart. As Ron said it's quite heavy and pretty wide so two people is really the only way.
[Image: https://farm2.staticflickr.com/1769/2854...f097_c.jpg]
It *just* barely fit in the back of the SUV. And as you can see in all the excitement I made the rookie mistake of not loading it top first so that it would be easier to unload. 
Fortunately it didn't end up being a problem - my wife helped me unload it and together we got it out without incident.
I'll post a few other pictures in the Phinds and Losses for July. 
Posts: 16,507
Threads: 572
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
The cabinet looks very nice.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Posts: 670
Threads: 11
Joined: Sep 2014
City: Bellmawr, NJ
Looks like a very nice set
Posts: 178
Threads: 19
Joined: Feb 2014
City: The Motor City,Detroit MI
I remember when I bought mine 40 years ago. I brought it home in the trunk of my '72 Ford LTD.
It was my first wood radio. It got a lot of listening time. Still have it.
Yours looks better than mine. Yours still has the original BOL phonograph. What is the item on the top left on the back side of the cabinet?
(This post was last modified: 07-27-2018, 04:49 PM by Kestas.)
Posts: 7,301
Threads: 269
Joined: Dec 2009
City: Roslyn Pa
> I bought mine 40 years ago. I brought it home in the trunk of my '72 Ford LTD.
Back when men were men and trunks were really trunks!! That was the yr I got my dl.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 1,889
Threads: 214
Joined: May 2015
City: Seattle
State, Province, Country: WA
Yeah, yeah. I brought mine home in a Subaru Forester.
It's just not the same. 
Posts: 1,889
Threads: 214
Joined: May 2015
City: Seattle
State, Province, Country: WA
(07-27-2018, 12:42 PM)Kestas Wrote: Yours looks better than mine. Yours still has the original BOL phonograph. What is the item on the top left on the back side of the cabinet?
The BOL will be a whole project unto itself. I've restored one other phonograph previously - a 46-1203 - which was frozen up because all of the grease had petrified. I got that unstuck and replaced the crystal cartridge. This seems like it could be much more challenging. I will likely send the BOL head off to West Tech for repair (I'm assuming it's going to need it)
Here's a closer pic of the back:
[Image: https://farm1.staticflickr.com/844/43366...b393_c.jpg]
I believe it's labeled 32-8196 which the service notes say is part #118 - the Phono Input Transformer.
Posts: 178
Threads: 19
Joined: Feb 2014
City: The Motor City,Detroit MI
I bought a parts Philco to harvest the BOL phonograph. I'll have to check if it has that transformer.
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Testing a speaker and output transformer Trutone A2-G
|
| MrFixr
Honestly, I haven't done that yet and do not want to screw up the threads; maybe you could do it, or we could...morzh — 12:48 PM |
|
Two small radios from France. Restoration and review.
|
| Greetings;
I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM |
|
Philco model 38 code 121 not receiving signal.
|
| Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM |
|
Philco model 38 code 121 not receiving signal.
|
| Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM |
|
Philco Battery-WWII vintage
|
| Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM |
|
Testing a speaker and output transformer Trutone A2-G
|
| Hi Morzh,
From my end, no. I did not know that there are 2 threads on this topic. Maybe it should be combined.MrFixr55 — 07:13 AM |
|
Testing a speaker and output transformer Trutone A2-G
|
| Any reason for the 2nd copy of the thread?morzh — 10:22 PM |
|
Testing a speaker and output transformer Trutone A2-G
|
| Sorry Murf, technical is what I do.
OK, Unlike the Western Auto Tru-Tones, this True Tone is a Wells Gardner set. Th...MrFixr55 — 09:31 PM |
|
Philco model 38 code 121 not receiving signal.
|
| You should be able to inject an audio signal such as from a CD or mP3into the radio at the volume control. The set will...MrFixr55 — 08:14 PM |
|
Testin a speaker and output transformer Trutone A2-G
|
| Hey Murf, this shouldn't be too difficult if it happens all the time. I'm assuming this is the 1938 Wells Gardner A2 wit...RodB — 05:46 PM |
|
Who's Online
|
There are currently 567 online users. [Complete List]
» 3 Member(s) | 564 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
