Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1941 Philco escutcheon Screws
#1

I've trying to find the small Bronze colored oval head screws that attach the plastic dial cover on the 41 philcos. I've tried to use other screws , but they just do not look right.
Any suggestions ?
#2

Try Restoration Hardware...... http://restorationhardware.com/

Probably one near you. See their Store Locator.

Chuck
#3

Unless you live in a large metropolitan area, you may be out of luck on finding a Restoration Hardware store. I checked my area...closest Restoration Hardware stores to me are in Indianapolis, Cincinnati, and Nashville. They aren't even in Louisville! Icon_sad

--
Ron Ramirez
Ferdinand IN
#4

The closest one to me is in near Orlando, about a 100 mile drive.
So far I found some HO model train track screws that don't look too bad.
Thanks for the info.
Al
#5

I have seen these screws at local hardware stores; I think I have even seen them at Lowe's. I bought some a while back to replace some screws on an early 1940s Philco escutcheon, but I don't remember where I bought them. Must be getting old. Hmpf. Icon_confused

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2886 online users. [Complete List]
» 1 Member(s) | 2885 Guest(s)
Avatar

>