Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

#1

I have a chance to pickup a model 38-4. I really don't have the room, but is this a set worth getting. The price is good, but wondering if it's a good sounding radio. Your opinions are greatly appreciated.
Glenn Icon_biggrin

Happily back in Illinois..not.
#2

I don't recall how well they sound, but with 8 tubes, a 38-4 should be a decent performer. If I'm not mistaken, the 38-4 has a push-pull output? That will help it to sound better than a smaller radio. (I could look this up, but I'm too lazy to do so right now.) Icon_lol

--
Ron Ramirez
Ferdinand IN
#3

Yup It's got P/P 6F6's no phase inverter and a rf amp. Boasts 5 watts of audio output. Should be a good performer!
Good luck w/it
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

Thanks for the input! Ron it's on Cl in Indy if your interested. It's a tad far for me. He asking $50 for it .

Happily back in Illinois..not.
#5

Thanks but no thanks...go for it if you don't mind the drive...no more consoles for me right now.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5460 online users. [Complete List]
» 1 Member(s) | 5459 Guest(s)
Avatar

>